No SBEM Results: SBEM May Have Run Out of Memory
As the message above states this error usually appears when running a simulation on a model that has too many zones for the SBEM engine to handle that it eventually runs out of memory. Usually we find clients run into this problem if they have over 350 zones/rooms and for SBEM-EPC it's a lot less (As you’re also simulating the reference & typical buildings as well as the actual & notional).
To get around this problem you can either:
1. Reduce the number of zones by combining or deleting spaces in ModelIT.
2. You can run the model using ApacheSim method as it has no restrictions on model size (until you get into the 5000 zone range).
Occasionally this error is displayed when there has been some other error during the SBEM calculations, please check the SBEM error log (model.err file in the project regs\SBEM\BRUKL or \SBEM\EPC folder).
products
