Trial / Demo
Why do the contours not go right to the edge of the image?
There are two reasons why the contours may not go right to the edge:
1. The square grid cells (at the user-specified size) cannot usually completely fill the surface - they start at the bottom left, so at top and right there may be a gap of up to, but no more than, 1 grid size.
2. Contours can only be calculated as far as the mid-point of the cells at the edges (the mid-point of any cell is the point at which the illuminance is calculated). In other words if contours are selected there will be an apparent gap of 1/2 a grid size. To minimise this effect reduce the grid size.
1389
products
Capella Building,
7th Floor,
60 York Street,
Glasgow,
G2 8JX,
UK
Tel:
+44 (0) 141 945 8500
Email:
enquiries@iesve.com
© 2011-
2025
Integrated Environmental Solutions Limited. All rights reserved |
Legal